This is the DIY low cost version of the Gergo. For presoldered boards see the Gergo: Partial, for ready to use keyboards see Gergo: Ready.
Tired of bulky Pro Micros being strapped onto every board? Us too. The Gergo uses only tiny surface mount components to bring you closer to your desk. Based on the Atmega32u4, this board is QMK compatible and comes pre-flashed! There's even support for our gUnit modules on the right side.
This kit includes everything you need (except a TRRS and MiniUSB cable). Cases are in the works, but you don't need them. We've included some risers to keep the components off your desk. We recommend having prior soldering experience, as there are a few fine pitch components. If you're not up for a challenge we offer pre-soldered and tested boards, just add your switches and go! Please look at the processor before ordering to see what the pin pitch is like!
The overall height of this board with the provided risers is less then a centimeter off your desk. Perfect for a bag, or use without wrist supports.
Check out our installation guide page for help on chucking her together. As with all of our products we offer assembly services that include firmware flashing and testing, if you want that please go take a look at the Gergo: Partial!
Current revision: Protocol